Configuring http trl defaults – Brocade Communications Systems ServerIron ADX 12.4.00a User Manual
Page 33

ServerIron ADX Security Guide
19
53-1002440-03
Configuring HTTP TRL
1
Syntax: [no] http-trl-policy
2. Configure an HTTP TRL client maximum connection.
ServerIronADX(config-http-trl-p1)# client-name c1 max-conn 10
Syntax: [no] client-name
3. Configure the action to take if a client exceeds the configured maximum connections
(optional).
ServerIronADX(config-http-trl-p1)# client-name c1 exceed-action reset
Syntax: [no] client-name
Configuring HTTP TRL defaults
Use the following procedures to configure the HTTP TRL default rate limit and the default maximum
connection.
Configuring HTTP TRL default rate limit
To configure HTTP TRL default rate limit, follow these steps.
1. Define an HTTP TRL policy.
ServerIronADX(config)# http-trl-policy p1
Syntax: [no] http-trl-policy
2. Configure an HTTP TRL default rate limit.
ServerIronADX(config-http-trl-p1)# default monitor-interval 1 10 20 0
Syntax: [no] default monitor-interval
3. Configure the action to take if a client exceeds the configured rate limit (optional).
ServerIronADX(config-http-trl-p1)# default exceed-action reset
Syntax: [no] default exceed-action reset
Configuring HTTP TRL default maximum connection
To configure HTTP TRL default maximum connection, follow these steps.
1. Define an HTTP TRL policy.
ServerIronADX(config)# http-trl-policy p1
Syntax: [no] http-trl-policy
2. Configure an HTTP TRL default maximum connection.
ServerIronADX(config-http-trl-p1)# default max-conn 10
Syntax: [no] default max-conn
3. Configure the action to take if a client exceeds the configured maximum connection (optional).
ServerIronADX(config-http-trl-p1)# default exceed-action reset