Brocade Communications Systems ServerIron ADX 12.4.00a - Manual (Page 126)

112 ServerIron ADX Security Guide
53-1002440-03
Clearing NAT entries from the table
4
Syntax: show ip nat redundancy
Displaying VRRPE information
To display VRRPE information, enter the following command.
Syntax: show ip vrrp-e brief
Clearing NAT entries from the table
Use the clear ip nat command to manually clear entries from the NAT table.
Syntax: clear ip nat inside
The parameter specifies the protocol type and can be tcp or udp plus its global or local
port number.
To clear a specific NAT entry based on the private and global IP addresses, enter the command
such as the following.
ServerIronADX# clear ip nat inside 209.157.1.43 10.10.10.5
This command clears the inside NAT entry that maps private address 10.10.10.5 to Internet
address 209.157.1.43.
Syntax: clear ip nat inside
To clear all static and dynamic entries from the NAT translation table, enter the following command.
ServerIronADX# clear ip nat all
Syntax: clear ip nat all
ServerIronADX# show ip nat redundancy (on standby)
NAT Pool Start IP: 10.1.1.150 Mac address: 020c.db01.0196
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.91 Mac address: 020c.db01.015b
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.92 Mac address: 020c.db01.015c
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.95 Mac address: 020c.db01.015f
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
ServerIronADX_Lower# show ip vrrp-e brief
Total number of VRRP-Extended routers defined: 2
Interface VRID CurPri P State Master addr Backup addr VIP
v5 1 125 P Master Local Unknown 5.1.1.9
v10 2 125 P Master Local Unknown 10.1.1.9