Pioneer AVM-P9000R - Manual (Page 77)

76
Fine Adjusting Audio (Expert)
Adjusting the Speakers’ Output Levels using a Test Tone
A convenient test tone allows you to easily get the overall balance right among the speakers.
1. Select “Test Tone” by moving the joystick.
“Test Tone” is highlighted in green.
2. Click the joystick.
The test tone is output. It rotates from speaker to speak-
er in the following sequence at intervals of about 2 sec-
onds. The current settings for the speaker over which
you hear the test tone are shown in the lower right-
hand corner of the screen.
Front Left
= Center = Front Right = Rear Right = Rear Left = Subwoofer
Check each speaker’s output level. If no adjustments are needed, perform step 5 to
stop the test tone.
Note:
• The settings do not appear for speakers whose Size is set OFF.
3. Adjust the speakers’ output level by moving
the joystick up/down.
The display shows “–10 dB” – “+10 dB”.
The test tone rotates to next speaker after about 2 sec-
onds from the last joystick operation.
4. Repeat step 3, make adjustment of the other
speakers’ output level.
5. Complete the procedure by clicking the joystick.
Note:
• If needed, select speakers and adjust their ‘absolute’ output level, refer to “Adjustments for
Speaker”. (See page 68.)
• To adjust the speakers’ output level at the Speaker Setting Menu is the same as making an
speakers’ output level at the Expert Setting Menu. Both provide the same results.