Pioneer AVM-P9000R - Manual (Page 74)

Adjusting Audio (Basic) 4. Click the joystick.
Each click toggles the selected SFC mode On/Off. Switch the SFC mode On to expe-
rience a sense of presence and spaciousness.
Dynamic Range Control
The dynamic range refers to the difference between the largest and softest sounds. The
dynamic range control compresses this difference so that you can clearly hear sounds even at
low volume levels.
1. Select “D. Range Control” by moving the joy-
stick.
“D. Range Control” is highlighted in green.
2. Click the joystick.
Each click toggles the Dynamic Range Control On/Off.
Note:
• The Dynamic Range Control is effective only on Dolby Digital sounds.
Direct Control ON/OFF
You can override audio settings to check for effectiveness of your audio settings.
1. Select “DIRECT” by moving the joystick.
“DIRECT” is highlighted in green.
2. Click the joystick.
Each click toggles DIRECT ON/OFF.
When this feature is turned on, “DIRECT ON” appears
in the center of the screen.
Note:
• All audio functions are locked out during DIRECT ON except VOLUME.
73
Remarks on Dolby PRO LOGIC ON/OFF
• If the source is a 2-channel LPCM audio or a 2-channel Dolby Digital audio and you select SFC
effects that are most applicable for 5.1-channel audio (i.e., Musical, Drama, Action or 5D), we
recommend switching Dolby Pro Logic ON. On the other hand, when selecting SFC effects that
are intended for use with 2-channel audio (i.e., Jazz, Club, Hall or Theater), we recommend
switching Dolby Pro Logic OFF.
• When playing a 2-channel mono source with PRO LOGIC switched ON, there are occasions
when the following will occur:
No audio is output if the center speaker setting is “ON” while no center speaker is installed.
Audio is heard only over the center speaker if installed and the center speaker setting is “ON”.