Pioneer AVM-P9000R - Manual (Page 70)

69
3. Select the speaker you want to make adjust-
ments to by moving the joystick.
The currently selected speaker is highlighted in green.
4. Click the joystick.
and are displayed and you can set the size and
the level for the selected speaker.
5. Select the correct size for the selected speaker
in use by moving the joystick left/right.
Select the speaker settings as follows:
Speakers Setting
Front (Left & Right) SMALL/LARGE
Rear (Left & Right) OFF/SMALL/LARGE
Center OFF/SMALL/LARGE
Sub Woofer OFF/ON
Note:
• The Front Left and Right speakers cannot be set differently. The same is true for the Rear Left
and Right.
6. Adjust the speaker for output level by moving the joystick up/down.
When you make adjustments for listening position, the speakers are automatically set
for appropriate output levels. You can tailor them if you want as discussed under the
heading of “Adjusting the Speakers’ Output Levels using a Test Tone” or “Adjusting
the Speakers’ Output Level”.
7. Click the joystick.
This completes adjustment to the selected speaker.
8. Repeat steps 3 – 7 for other speakers.
Precaution:
• Low frequency range is not output if the subwoofer is set “OFF” and the front or rear speakers
set “SMALL” or “OFF”.
Note:
• It is imperative that non-installed speakers be set to “OFF”.
• Set the front or rear speaker to “LARGE” if the speaker is capable of reproducing bass con-
tent, or if no subwoofer is installed.
• When playing a 2-channel mono source with PRO LOGIC switched ON, there are occasions
when the following will occur:
No audio is output if the center speaker setting is “ON” while no center speaker is installed.
Audio is heard only over the center speaker if installed and the center speaker setting is “ON”.
Adjusting Audio (Basic)
Size Level