Agilent Technologies FS2010 - Manual (Page 30)

30
Due to the FS2010 being an interposer all signals are extended 1.2 in. in
length, consisting of 57 ohm single-ended impedance etch.
All PCI-X Local Bus operations are supported by the hardware and the
inverse assembler.
Operating:0 to 55 degrees C (+32 to +131 degrees F)
Non operating:-40 to +75 degrees C (-40 to +167 degrees F)
Operating: 4,6000m (15,000 ft)
Non operating: 15,3000m (50,000 ft)
Up to 90% non-condensing. Avoid sudden, extreme temperature
changes which would cause condensation on the FS2010 module.
There are no automatic performance tests or adjustments for the
FS2010 module. If a failure is suspected in the FS2010 module contact
the factory or your FuturePlus Systems authorized distributor.
The repair strategy for the FS2010 is module replacement. However, if
parts of the FS2010 module are damaged or lost contact the factory for a
list of replacement parts.
The FS2010 contains 3 Samtec connectors which the adapter cables
connect to. Each adapter cable contains 2 connectors to connect to the
Agilent logic analyzer.
The FS2010 module monitors signals for both state and timing analysis.
The following tables list the PCI-X Local Bus signals on the 6 cables.
Etch length
Operations
Environmental
Temperature
Altitude
Humidity
Testing and
Troubleshooting
Servicing
Signal Connections
The State/Timing
Adapter Probe interface
pinout