Agilent Technologies FS2010 - Manual (Page 29)

29
General Information
This chapter provides additional reference information including the
characteristics and signal connections for the FS2010 module.
The following operating characteristics are not specifications, but are
typical operating characteristics for the FS2010 module.
32 or 64 bit PCI-X Local bus universal connector pinout. All PCI-X local
bus ground pins of the universal board pinout are connected to the
ground plane of the FS2010 module.
The FS2010 extender card connector is a 3.3V, 64 bit connector that
accepts either 3.3V or universal 32 or 64 bit long or short card form
factor. All of the signals from the PCI-X bus are routed to the card edge
extender connector.
The PCI-X Local Bus Specification Revision 1.0
The FS2010 State/Timing Adapter Probe logic contains no active
components. The PCI-X add-in card installed in the FS2010 can draw
power from the +/-12V, 3.3V and the 5V pins of the target as if it were
installed without the FS2010.
Agilent 16715/6/7/9, 1674X, or 16750/1/2, 16953/4/5/6 installed in the
16700A or 16700B mainframe. Agilent 1680/90/900, 16953/4/5/6, 1691x,
1695x logic analyzers.
The State/Timing Adapter Probe interface uses 4 cable headers for 32
bit analysis and 6 for 64 bit analysis.
0 to 133Mhz
Characteristics
State/Timing Adapter
Probe Interface
Compatibility
Card Edge Extender
Connector
Standards Supported
Power Requirements
Logic Analyzer Required
Number of Probes Used
Minimum Clock Period
(State)