Agilent Technologies FS2010 - Manual (Page 11)

11
To install the FS2010 software, insert the diskette labeled 16700/702
Installation disk for the FS2010 into the Agilent 16700 diskette drive.
From the SYSTEM ADMINISTRATION TOOLS select INSTALL under
SOFTWARE. From the SOFTWARE INSTALL screen select the
FLEXIBLE DISK and APPLY. Once the title appears select it and then
select INSTALL.
This procedure does not need to be repeated. It only needs to be
done the first time the PCI-X Analysis Probe is used.
When this has completed, load the appropriate configuration file from the
/configs/FuturePlus/FS2010 directory. Refer to the table on the following
pages for a list of analyzers and corresponding configuration files.
The FS2010 product is a licensed product, which is locked to a single
Agilent 1670x frame. Complete instructions for licensing this software
are detailed on the Entitlement Certificate that is enclosed with this
product.
The licensing area for the 1670x mainframe is found under System
Administration. Once you are at the licensing area choose the
Processor/Bus Solutions tab, in here you will find the PCIX inverse
assembler listed. Type your password in the space provided to enable
the use of the inverse assembler. A demo period is provided by typing
the word demo into the password space next to the product name.
The following picture shows the licensing area after pressing the
licensing button on the previous screen. This is where you would enter
the password you will receive after following the instructions on the SW
License Entitlement Certificate.
Setting up the 167xx
Analyzer
167xx
Licensing