AEG Voxtel D215 combo - Manual (Page 21)

21
UK
10.4 Set the Auto Answer
If you turn on the Auto Answer, you can answer a call automatically by just lifting the handset off the base
or charger, without having to press any key.
tPress and
/ to select “HS SETTINGS“.
tPress and / to select “AUTO ANSWER“.
tPress and / to turn on or off the auto answer feature.
tPress to confirm.
10.5 Base Settings
Using the cordless handset:
10.5.1 De-register a Handset
This operation should only be necessary if one of your handsets becomes faulty or lost and needs to be
replaced.
You will need to enter the 4-digit System PIN (Default PIN is 0000) in order to de-register a handset from
the base station. A de-registered handset will have the antenna icon flashing and “REGISTER” on the
display.
Note:
You cannot de-register the handset that you are currently using.
tPress and
/ to select “BS SETTINGS“.
tPress to show “DELETE HS“.
tPress and the display shows “PIN? ------”.
tEnter the 4-digit system PIN (default 0000).
tPress and the first handset number is displayed.
tPress
/ to scroll through the list of registered handsets and select the number of the handset you
want to de-register.
tPress to confirm, and the chosen handset will be de-registered.
10.5.2 Change the dial mode
You should normally leave the dialling mode at its default setting of “TONE“ (also called DTMF) unless the
phone is connected to an old exchange that only recognises “PULSE“ dialling.
Note:
If “PULSE“ dialling is set, you can press the * key to switch to “TONE“ dialling for the rest of that call.
tPress and / to select “BS SETTINGS“.
tPress and
/ to select “DIAL MODE“.
tPress and
/ to select “TONE“ or “PULSE“ (The current setting is indicated by an asterisk to the
right).
tPress to confirm.
10.5.3 Change the Flash (Recall) Time
You may need to change the recall (flash) time if your phone is connected to a PBX. The recall time options
are “SHORT“ (the default value of 100ms), “MEDIUM“ (300ms) or “LONG“ (600ms).
tPress and
/ to select “BS SETTINGS“.
tPress and
/ to select “FLASH TIME“.
tPress and
/ to select your desired flash time (“SHORT“, “MEDIUM“, “LONG“, with the current
setting indicated by an asterisk to the right).
tPress to confirm.
10.5.4 Change the System PIN Code
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to protect
your phone against unauthorised use. The default system PIN code is “0000“.
tPress and
/ to select “BS SETTINGS“.
tPress and / to select “CHANGE PIN“.