AEG Voxtel D215 combo - Manual (Page 12)

12
Note:
It is not possible to dial numbers from memories or use the speakerphone when the mains power is off.
When the mains power is off, you can also answer an incoming call with the corded handset.
When the phone rings, pick up the corded handset to talk to the caller.
7.16 Redial
You can redial any of the last 10 numbers called. If you have stored a name in the phonebook to go with
the number, the name will be displayed as well.
7.16.1 Redial a Number from the Redial List
In idle mode, press to view the redial list.
Note:
The redial list can also be viewed using then selecting “CALL LOG“ and “DIALED“.
1. Press / to browse the redial list.
2. Pick up the corded handset or press to dial the selected redial number.
Note:
If no numbers are in the redial list, the display will show “EMPTY“.
7.16.2 Save a redial number into the phonebook
tFollow steps 1 and 2 in section 7.16.1.
tPress to show “ADD TO PB?“
tPress and then enter the name for the phonebook entry.
tPress and then modify the number, if necessary.
tPress and then
/ to select a melody.
Note:
The selected melody will only play when you receive a call if you subscribe to Caller Display and the
incoming number matches the stored number.
tPress to save the redial number into the phonebook.
7.16.3 Delete a Redial Number
tFollow steps 1 and 2 in section 7.16.1.
tPress and
/ to select “DELETE?“.
tPress to show “CONFIRM?“.
tPress to confirm the delete.
7.16.4 Delete All Redial List Entries
tIn idle mode, press to open the redial list.
tPress and / to select “DELETE ALL?“.
tPress to show “CONFIRM?“.
tPress to confirm the delete, and briefly display “EMPTY“.
7.17 Find the Cordless Handset
Using a cordless handset:
If you have more than one cordless handset registered to the base, press
and select the handset
number to call the other handset, or press 9 to call all registered handsets.
Note:
If there is an incoming call during the intercom calling, the phone will ring with the incoming call instead
of the intercom.
Using the corded base:
You can locate any cordless handsets by paging from the base unit:
tIn idle mode, press and
/ to select “PAGE ALL HS“.
tPress “PAGING“ will flash on the base screen.