Xerox WorkCentre C2424-3836 - Manual (Page 9)

Adjusting Copying Options
WorkCentre® C2424 Copier-Printer
3-9
3. Select one of the following, then press the Enter button:
■ 100% – Keeps the copy image the same size as the original. (Factory default value).
■ Auto – Reduces or enlarges the image as needed to fit the full size of the copy paper.
■ Preset – Reduces or enlarges the image as needed to fit a selected copy paper size.
■ 25%-400% – Reduces or enlarges the image by a selected percentage.
■ Poster 4x4 – Enlarges the image to fit onto 16 copy pages so that it can be assembled
into a 4x4 poster.
4. If you selected Preset , select the preset value, the size of the original followed by the size
of the copy paper.
5. If you selected 25%-400% , use the keypad to enter a value from 25% to 400% (in 1%
increments) or press the Up Arrow or Down Arrow button to scroll to the desired value,
then press the Enter button.
Lightening or Darkening the Image
To lighten or darken the image when it is copied:
1. On the control panel, press the Copy button.
2. In the menu, select Lighten/Darken , then press the Enter button.
Note
You can press the Lighten/Darken shortcut button on the control panel to skip Steps 1
and 2.
3. Press the Up Arrow or Down Arrow button to scroll to a whole number from
Darkest (+3) to Lightest (-3) , then press the Enter button.
Adjusting the Contrast of the Image
To reduce or increase the contrast of the image when it is copied:
1. On the control panel, press the Copy button.
2. In the menu, select Contrast , then press the Enter button.
3. Press the Up Arrow or Down Arrow button to scroll to a whole number from
Highest (+3) to Lowest (-3) , then press the Enter button. The factory default is 0 .
Automatically Suppressing Background Variations
Sometimes, two-sided originals on thin paper show some of the text or images from the back
side of the paper. To improve your copies from this type of original, use the
Auto
Suppression setting to minimize the sensitivity of the scanner to variations in light
background colors.
To change this setting:
1. On the control panel, press the Copy button.
2. In the menu, select Auto Suppression , then press the Enter button.
3. Select either On or Off , then press the Enter button. The factory default is Off .