Konica Minolta BIZHUB C30P - Manual (Page 53)

6 Configuring PageScope Net Care Settings
42
To add a network to the discovery range
1. On the Discovery Setting screen, click the Add button in the
Discovery Network / Range section. Network setting items are
shown in the Input Network Range section.
2. Type the IP address of the network you want to add into the
Network Address boxes.
3. Type the subnet mask value of the network you want to add into
the
Subnet Mask box.
4. If you want to change the host address discovery range, input the
start address into the
Discovery From box, and the end address
into the Discovery To box.
In the HTML mode, no values are input automatically into the
Discovery From and Discovery To boxes, and they can be left
blank, if you want. Leaving these boxes blank searches within the
range specified by the
Network Address and Subnet Mask
boxes. If you want to specify a range, input the start address into
the
Discovery From box and the end address into the Discovery
To box.
5. After everything is the way you want, click the Apply button. To
clear all settings you have made on the setup screen, click the
Cancel button.