Konica Minolta BIZHUB C30P - Manual (Page 51)

6 Configuring PageScope Net Care Settings
40
Discovery Setting section
• IP Broadcast: Select Enabled if an IP broadcast is to be
used when searching for devices. A broadcast
is sent to devices on the network and a search
is performed. This increases the speed of the
search; however, devices that are not
compatible with the broadcast cannot be
found.
• SNMP Ping: Select Enabled if an SNMP ping is to be used
when searching for devices.
An SNMP request is sent to all devices within
a network search range and a search is
performed. This reduces the speed of the
search; however, a more reliable result can be
achieved.
SNMP Setting section
• Time Out: Type in the length of time (in milliseconds, 1
second = 1000 milliseconds) to wait for a
response when searching for devices.
• Retries: Type in the number of attempts that are made
when a search for devices fails.
• SNMPv1 Table: Add or remove read community names and
port numbers used when searching for devices
compatible with SNMPv1.
(Refer to “To add settings used with a search
for devices compatible with SNMPv1” (p. 44)
and “To remove settings used with a search
for devices compatible with SNMPv1”
(p. 44).)