Konica Minolta KIP 9000 - Manual (Page 32)

Chapter 2 Basic Operations 2-9
7. Using a slit on each drawer, cut off the leading part of roll media with a cutter knife to straighten
the leading edge.
NOTE
Do not feed any media with tape or adhesive remaining on it. It is best to trim at least one full
revolution from the roll when installing a new roll.
8. Insert the leading edge of media between feeding rollers, and rotate the upper feeding roller to
pinch the leading edge (1-2cm) with the rollers.
NOTE
The Roll Deck 3 only has a positioning hole. (Other Rolls do not have it.)
Feed the roll media until its leading edge comes to appear in the hole, and place the leading
edge at the center of the hole.
Positioning hole
Slit
Feeding rollers