Konica Minolta KIP 9000 - Manual (Page 121)

Chapter 3 Error Correction & Maintenance 3-20
5. Rotate the Cutter Handle for 1 revolution clockwise to cut the roll media.
NOTE
The Cutter Blade needs to be placed at its home position correctly after the above operation.
After cutting the media rotating the Cutter Handle, place the green part inside of the notch.
If red part is seen in the notch, the Cutter Blade is not correctly placed to its home position.
And at this time take care for the following points.
• Do not rotate the Cutter Handle counter-clockwise. It will damage the Cutter Blade.
• Do not rotate the Cutter Handle more than once. If it is rotated many times, very small
paper portion will be left in the cutter unit. This will cause the error.
Correct (Green) Incorrect (Red)
Cutter Handle