Konica Minolta bizhub PRO 1050P - Manual (Page 34)

30
Using Folding Unit FD-503
The following punch/folding patterns are available:
Punch : 2 or 3 holes can be punched in sheets for filing purposes. Set left/right/
top position according to the placement of sheets.
Folding: Six folding types are available - Z-Fold, Letter Fold-in, Letter Fold-out,
Double Parallel, Gate, and Folding. Choose to print outside the fold
(outside print) or inside (inside print) for each folding mode except Z-fold.
With Folding Unit FD-503 installed on the machine as a single finishing option, the
two output trays are available, to each of which is allotted with output modes as
described below.
Primary (Main) tray: Half Fold, Z-Fold, Punch, Non-sort (straight delivery)
Fold mode tray: Tri-Fold-in, Tri-Fold-out, Double Parallel, Gate Fold
A secondary (sub) tray is also available in place of the fold mode tray.
Contact your service representative, if desired.
4.252"
(108 mm)
2.756"
(70 mm)
Letter Fold-in Double Parallel Gate
Letter Fold-out Z-Fold Folding