beautypg.com

9 troubleshooting, 1 cannot connect to the scanner, Troubleshooting – Konica Minolta bizhub PRO 1200 User Manual

Page 155: Cannot connect to the scanner -2, Chapter 9 troubleshooting, 9troubleshooting

background image

9

Troubleshooting

9-2

bizhub PRO 1200/1051 Scanner

Tro

uble

s

hoo

tin

g

Chapter 9

9

Troubleshooting

9.1

Cannot connect to the scanner

If an error message appears when attempting to access the scanner, perform
the following checks:

0 Consult your network administrator about your network settings.

1

Check whether the correct IP address of the scanner has been entered.

If the IP address is not correct, enter the correct one.

If the entered IP address is correct, go on to step 2.

2

From the DOS prompt of the PC you use, execute “ping” to the IP ad-
dress of the address to which a connection is made to check to see if
the connection is made properly.

To confirm the IP Address of the copier, contact your network ad-
ministrator.
e.g. : C:/>ping 192.168.0.1

If the ping test fails, check whether the copier's main power is
switched on, and also check the network cable for proper connec-
tion.

If the ping test is successful, go on to step 3.

3

Check whether the IP router is correctly set.

If it is not correctly set, set it correctly.

If there is no problem in IP router setup, go on to step 4.

4

Trace the routing to the scanner to check whether there are any error
conditions within the network.

If any error conditions are found, eliminate them.

If no error is found and yet the connection to the scanner cannot be
established, contact your service representative.

!

Detail

When the Security Strengthen mode is ON, A job is unacquirable using
applications compatible with TWAIN and network scanner driver. For
more information, contact your administrator.

This manual is related to the following products: