Konica Minolta KIP 7900 - Manual (Page 19)

KIP Unattend Operator Guide
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP America, Inc. © 2011 KIP America, Inc.
- 17 -
SleepColdDelay=5340
Value is a number of seconds. If the engine is in a “Warm Sleep” state, and a print is not received within
this number of seconds, the fuser temperature is lowered even further to room temperature. Value 0
disables Cold Sleep mode.
SleepColdStandBy=False
Puts the KIP IPS into Standby Mode.
ColdStartTime=
The information entered under ‘Windows Unattend – Configuration – Misc settings’ in the screen below is
duplicated in the Winuntd.ini for ColdStartime and ColdStoptime. ColdStartime refers to the time when
the software will signal the printer to go into Cold sleep mode. Coldstoptime refers to Wake time that
sends the printer to ‘warm up’. Users can normally put the Sleep time at 20:00 (8PM) and Wake time at
06:00 (6AM).
ColdStopTime=
See above
Advanced Sleep=
Feeder5Paper=6
Utilized with the KIP 8000, KIP 9000 & KIP 9900
IdleWait=0
MeterPeriod=
MeterDate=
MeterDay=
MeterTime=
MeterReportDate=12:00:00 AM
This section is used for the Print Reports Setting utilized in KIP PrintNet