Konica Minolta magicolor 1690MF - Manual (Page 238)

Solving Other Problems 9-27
Printing
takes too
much time. The machine is set to
a slow printing mode
(for example, thick
stock). It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The machine is set to
power saving mode. It takes time for printing to start in
power saving mode.
The job is very com-
plex. Wait. No action needed.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed
(
Wrong Toner X
is displayed in the
message window).
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific machine.
If an error has been
detected during print-
ing job transmission
in the Copy mode, it
takes a while to pro-
cess the error and
resume the printing
operation. Wait. No action needed.
Blank pages
are printed. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
will not print correctly or not at all, if the
cartridges are empty.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
machine.
Not all pages
print. A different user acci-
dentally canceled the
job. Try printing the remaining pages.
The tray is empty. Check that the tray is loaded with
media, in place, and secure.
A document is printed
with an overlay file
which has been cre-
ated by an unsuit-
able printer driver. Print the overlay file using a suitable
printer driver.
Symptom Cause Solution