Konica Minolta bizhub C10X - Manual (Page 57)

Print Media 43
DO NOT use thick stock that is
„
Mixed with any other media in the trays (as this will cause media misfeed-
ing)
Envelope
Print on the front (address) side only. Some parts of the envelope consist of
three layers of paper—the front, back, and flap. Anything printed in these lay-
ered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
"
43 lb bond is also referred to as 90 lb index stock.
Use envelopes that are
„
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
"
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
„ Approved for laser printing
„ Dry
DO NOT use envelopes that have
„
Sticky flaps
„ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
„ Transparent windows
„ Too rough of a surface
„ Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
„ Been presealed
Capacity Tray 1 Up to 10 sheets, depending on their thick-
ness
Tray 2 Not supported
Driver
Media Type Envelope
Duplexing Not supported