Konica Minolta bizhub C10X - Manual (Page 194)

Solving Other Problems 180
Printing
takes too
much time. The machine is set to
a slow printing mode
(for example, thick
stock or transpar-
ency). It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The machine is set to
power saving mode. It takes time for printing to start in
power saving mode.
The job is very com-
plex. Wait. No action needed.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed
(
X TONER INCOR-
RECT is displayed in
the message win-
dow).
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific machine.
Blank pages
are printed. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
will not print correctly or not at all, if the
cartridges are empty.
The wrong media is
being used. Check that the media type.
Not all pages
print. The Cancel key was
pressed. Make sure no one pressed the Cancel
key while your job was printing.
The tray is empty. Check that the tray is loaded with
media, in place, and secure.
A document is printed
with an overlay file
which has been cre-
ated by a bizhub C10
printer driver. Print the overlay file using a bizhub
C10 printer driver.
Some parts
of the image
are lost with
2in1 copying. If the Media type is
Envelope and the
zoom ratio for 2in1
copying will be less
than 50%, the zoom
ratio is set to 50%. Press the + or , key to adjust the
zoom ratio.
Symptom Cause Solution