Konica Minolta bizhub PRESS C1085 - Manual (Page 72)

Image Quality Adjustment 6
6-24 bizhub PRESS C1100/C1085 (IC-602)
6.2
12
When the message is displayed, click [OK] to
start the measurement.
13
Prepare the printed chart.
% Place five to 10 blank sheets of the same
color under the printed chart so that it will
not be affected by the color of the working
table.
% If a ruler is available, align it on the chart.
% To make the measurement, remove the
FD-5BT from the target mask.
14
Carry out the measurement in sequence from
row A.
% Hold down the side button of the FD-5BT.
When a bleep"" noise sounds, slide the
FD-5BT while holding down the side but-
ton.
Slide to the opposite side, then release
the side button.
% For details about how to use the FD-5BT,
refer to the manual supplied with this ma-
chine.
15
Likewise, measure rows B to E.
% The measured parts are color-displayed
on the screen in the same way as for the
chart.