Konica Minolta bizhub PRESS C1085 - Manual (Page 52)

Both Sides Adjustment 6
6-4 bizhub PRESS C1100/C1085 (IC-602)
6.1
6.1.3 Making the Both Sides Adjustment for each tray
Adjust a misalignment between the front and back sides, which is caused during the duplex printing, for each
tray.
The following two methods are available to carry out the Both Sides Adjustment.
- Chart Adjustment
- Zoom and Image Shift Adjustment
Tips
- You can register Both Sides Adjustment values in a paper profile with paper conditions specified. If pa-
per conditions are registered, you can carry out printing under the previous conditions even when you
have changed a tray to load paper into. For information about how to edit or register a paper profile,
refer to the [HTML User's Guide].
Chart Adjustment
You can print out a Both Sides Adjustment chart, measure measurement points using a scale, and enter
measurement values in order to carry out the adjustment.
Using this function, you can only enter measurement values to carry out the both-side adjustment. This is
convenient when an unclear misalignment is detected between the front and back sides to perform the du-
plex printing with a new type of paper or to change paper in a tray.
1
Press [Paper Setting] on the [MACHINE] screen.
2
Select the tray with the target paper loaded,
then press [Change Set].