ADC 410F - Manual (Page 87)

Appendix A: Specifications and Data
Megabit Modem 410F and 420F User Manual 79
H
ARDWARE
The following provides additional information about Megabit Modem 410F and 420F such as
the installation kit and modem connectors pinouts.
Installation Kit
The following items are included in the installation kit and are used to install each Megabit
Modem 410F and 420F as shown in
Chapter 3 on page 11 .
Part Description Function
Rubber feet Four black rubber feet Attach to the base of the modem.
Grey cable Silver-satin phone cord with 4-pin modular
plugs (straight-through) Connects the modem ADSL connector to the
wall phone jack for access to the Internet.
Black cable CAT 5, cable with 8-pin modular plugs
(straight-through) Connects the modem 10/100BASE-T connector
to the LAN through a hub or to a PC NIC.
Power cable Power supply with optional power cord (this
item is ordered dependent on the type of
power supply and cord required for your
location) Connects the modem POWER connector to the
local power source.
Screws Two 6x 1 /
2
-inch sheet metal screws Installs into a wall for wall-mounting modems.
Grey cable
and adapter Flat cable with RJ-45 connectors and a DB-9
to RJ-45 adapter. Connects the RS-232 management port to an
ASCII terminal or a PC running terminal
emulation software. Adapter assembly connects
to a DB-9 connector on the PC. Then, one RJ-45
connector installs in the adapter and the other
connector into the console port on the modem.