Usingthe rs232 management port for set up, Using the rs-232 management port for set up, Rs-232 – ADC 410F User Manual
Page 32: Sing the, Management, Ort for
Using the RS-232 management Port for Set Up
24
Megabit Modem 410F and 420F User Manual
U
SING THE
RS-232
MANAGEMENT
P
ORT FOR
S
ET
U
P
You can configure some parameter for the Megabit Modem 410F and 420F modems through
the RS-232 port that is connected to a PC. You can use the Megabit Modem Setup Menu to do
the following:
•
manually change the LAN and WAN IP address and network mask
•
enable Dynamic Host Configuration Protocol (DHCP)
•
configure modem parameters (these are a subset of the parameters that can be configured
using the Megabit Modem 410F and 420F Web pages)
Pairgain Megabit Modem 410F Setup Menu
========================================================
BSP version:
2.2
SW version:
2.8
========================================================
(1)Enter LAN IP address:
192.168.0.1
(2)Enter LAN IP network mask:
255.255.255.0
(3)Toggle Bridging:
Enabled
(4)Toggle Routing:
Disabled
(5)Toggle LAN DHCP:
Disabled
(6)Toggle Spanning Tree:
Enabled
(7)Enter WAN IP address:
(8)Enter WAN IP network mask:
(9)Toggle LAN RIP:
Enabled
(10)Toggle WAN RIP:
Enabled
(11)Enter default gateway IP address:
0.0.0.0
(12)Enter IP Admin address:
0.0.0.0
(13)Set Factory Defaults
(14)Reset modem
>