Configuring system settings, Chapter 5: configuring system settings, Onfiguring – ADC 410F User Manual
Page 49: Ystem, Ettings
Megabit Modem 410F and 420F User Manual
41
5
C
ONFIGURING
S
YSTEM
S
ETTINGS
Before configuring the connection between the Megabit Modem 410F and 420F, set up the
system parameters for each modem. The following sections show the Web pages you use to
configure system parameters. Set the:
•
TFTP server IP address and network mask for performing software upgrades on
when required
•
SNMP parameters on
•
system time and date on
•
system admin IP address on
Unless specified otherwise, configuration parameters shown in this section are for
example only.
After you set up system parameters, go to
,
“Configuring the Ports” on page 47
to
configure the LAN-WAN and ADSL parameters.
This manual is related to the following products: