Vollrath 238R User Manual

Page 26

A. To clean the freezer parts, disassemble all parts.

(Refer to Sec. 3.11 - 3.17 for the disassembly of

freezer parts.)

B. Place all parts in warm, mild detergent water and

wash thoroughly. Rinse all parts with clean, hot

water. The use of soft water is recommended, along

with dishwashing detergents such as Joy, Dawn, or

equivalent.

NOTE

Take care not to damage parts by dropping or rough

handling.

C. Wash hopper (hopper models), feed tube (remote

models), and freezer barrel with warm detergent

water and brushes provided. Rinse with clean, hot

water.

NOTE

On remote models, feed tube must be cleaned from

top and from the inside of the barrel, using the 1-1/

2" x 30" brush provided.

D. Clean the rear seal surface from the inside of the

freezer barrel.

E. Remove the rear drip tray by opening access door on

side panel. Clean and replace drip tray.

3.20 SANITIZE FREEZER PARTS

A. Use a sanitizer mixed according to manufacturer's

instructions to provide a 100 parts per million strength

solution. Mix sanitizer in quantities of no less than 2

gallons (7.5 liters) of 120°F water. Allow the sanitizer

to contact the surfaces to be sanitized for 5 minutes.

Any sanitizer must be used only in accordance with

the manufacturer's instructions.

B. Place all parts in the sanitizing solution, then remove

and let air dry.

C. Assembly freezer parts. (Refer to Sections 3.12B -

3.13B for the assembly of freezer parts.)

NOTE

Any cleaning procedure must always be followed

by sanitizing the assembled freezer before filling with

mix.