Vollrath 238R - Manual (Page 22)

14
K. Open spigot to expel water. When the hopper or pail
is empty, place the mix pump switch and main drive
switch in the OFF position. Allow freezer barrel to
drain completely.
L. Repeat steps E-K using mild detergent solution.
M. Repeat steps E-K using 120 to 130° F (49-54° C) hot
rinse water.
3.15 DISASSEMBLY AND ASSEMBLY OF FRONT DOOR
(MODEL 217 AND 237R)
To aid in the disassembly of the front door, refer to
Figure 11 and the following steps:
CAUTION
TURN FREEZER OFF AT MAIN DRIVE SWITCH
BEFORE DISASSEMBLING FOR CLEANING OR
SERVICING.
A. Disassembly of front door.
1. Remove the front door by unscrewing the black
knobs.
CAUTION
HAZARDOUS ROTATING BLADES-DO NOT OP-
ERATE UNIT WITH FRONT DOOR OR SPIGOT
REMOVED.
Figure 11
Front Door Disassembly
Allow the mix to agitate in freezer barrel until the mix has
become a liquid.
D. Place the mix pump in the ON position. Open spigot
and pump liquid mix through the freezer. When empty,
place main drive switch and the mix pump switches
in the OFF position.
E. Close spigot and fill hopper (hopper models) with
approximately two gallons of cold tap water.
NOTE
On remote models, place mix pump suction tube
into the pail of cold tap water.
F. Open air bleed valve on the front door by pushing
valve in and holding.
G. Place the mix pump switch in the ON position.
H. Let the cold water fill freezer to air bleed valve, then
close the valve by pulling out to lock in place.
I. Place the main drive switch in the CLEAN position.
J. Allow water to agitate until the inside surface of front
door has rinsed clean.
Model 237R
Front Door
Model 217/225
Front Door
"O" Ring placed INSIDE spigot
extension CASTLE TYPE ONLY
И И И И И