Cirrus Logic CS5526 - Manual (Page 24)

CS5525 CS5526
24 DS202F5
PIN DESCRIPTIONS
Clock Generator
XIN; XOUT - Crystal In; Crystal Out, Pins 9, 10.
A gate inside the chip is connected to these pins and can be used with a crystal to provide the
master clock for the device. Alternatively, an external (CMOS compatible) clock can be
supplied into the XIN pin to provide the master clock for the device.
Control Pins and Serial Data I/O
CS - Chip Select, Pin 18.
When active low, the port will recognize SCLK. When high the SDO pin will output a high
impedance state. CS should be changed when SCLK = 0.
SDI - Serial Data Input, Pin 17.
SDI is the input pin of the serial input port. Data will be input at a rate determined by SCLK.
SDO - Serial Data Output, Pin 14.
SDO is the serial data output. It will output a high impedance state if CS = 1.
SCLK - Serial Clock Input, Pin 11.
A clock signal on this pin determines the input/output rate of the data for the SDI/SDO pins
respectively. This input is a Schmitt trigger to allow for slow rise time signals. The SCLK pin
will recognize clocks only when CS is low.
A0, A1, A2, A3 - Logic Outputs, Pin 6, 7, 15, 16.
The logic states of A0-A3 mimic the states of the D20-D23 bits of the configuration register.
Logic Output 0 = AGND, and Logic Output 1 = VA+.
1
2
3
4
5
6
7
8
9
20
19
18
17
16
15
14
13
12
10 11
ANALOG GROUND AGND VREF+ VOLTAGE REFERENCE INPUT
POSITIVE ANALOG POWER VA+ VREF- VOLTAGE REFERENCE INPUT
DIFFERENTIAL ANALOG INPUT AIN+ CS CHIP SELECT
DIFFERENTIAL ANALOG INPUT AIN- SDI SERIAL DATA INPUT
NEGATIVE BIAS VOLTAGE NBV A3 LOGIC OUTPUT
LOGIC OUTPUT A0 A2 LOGIC OUTPUT
LOGIC OUTPUT A1 SDO SERIAL DATA OUTPUT
CHARGE PUMP DRIVE CPD VD+ POSITIVE DIGITAL POWER
CRYSTAL IN XIN DGND DIGITAL GROUND
CRYSTAL OUT XOUT SCLK SERIAL CLOCK INPUT