WIKA UT-11 - Manual (Page 23)

P
u
bl
is
he
d 1
6
.2.
04
C
Universal Pressure Transmitter UniTrans
Operation of Transmitters without Display
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg · (09372) 132 - 710 · Fax - 706 · E-mail: [email protected] · www.wika.de
62
5.5 Integration Time (Damping) Adjustment
The following integration time settings can be used: 0, 1, 5, 20 and 40 s.
The sensor’s measured values can then be averaged using the adjusted integration
time.
5.6 Reset to Default
All default data settings are restored by simultaneously pressing the "zero", "esc" and
the "ok" buttons for 2 seconds (see chapter 6.4).
Calibrated special measurement ranges i. e. 4 bar on a 6 bar transmit-
ter can be adjusted by factory pre-setting. A reset to default will reset
the sensor back to its nominal range (i. e. 6 bar). The factory pre-setting
gets lost.
Important
Reset to default
050-DS-GB
Calibration Value Function
(2 sec.) (2 sec.)
(2 sec.)
Calibration Value Calibration Value
Calibration of the integration time
(2 sec.) (2 sec.) (2 sec.)
4 times
028-DS-GB