WIKA UT-11 - Manual (Page 15)

P
u
bl
is
he
d 1
6
.2.
04
C
Universal Pressure Transmitter UniTrans
Installation
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / BRD
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg · (09372) 132 - 710 · Fax - 706 · E-mail: [email protected] · www.wika.de
54
4 Installation
The device should be installed/operated in accordance with the regulations of ElexV,
the Device Safety Regulation, this operating manual and generally recognized indus-
try standards.
4.1 Pressure Transmitter Installation
Installation Using a Weld-on Adapter:
• Insert a filler piece (a pressure transmitter dummy) into the weld-on adapter.
• Weld the adapter into the container/pipe wall (section-weld process).
• Remove the filler piece.
• Install the pressure transmitter in the weld-on adapter.
4.2 Display Unit Upgrades
The display unit can be easily upgraded at any time.
• Remove the housing cover and the supporting string.
• Attach the display unit’s supporting string to the same place.
• Plug the display unit’s connector into the appropriate jack.
The display unit can be mounted at 90° angles.
• Fasten the display unit with screws.
The pressure transmitter’s diaphram should not come into contact with
hard or sharp objects.
When installing the display unit, make sure that the connection cable
and the supporting string are not kinked or pinched.
Attention
Attention