When tightening the 4 – WIKA UT-11 User Manual

Page 16

Universal Pressure Transmitter UniTrans

Installation

d 1

.2.

Subject to change due to technical modifications.

WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg ·

(09372) 132 - 710 · Fax - 706 · E-mail: [email protected] · www.wika.de

•

All functions are programmable once the pressure transmitter has been upgraded
with a display unit. The adjusted parameters are stored after the display unit is re-
moved.

The display unit can be rotated in 300°, so that it can be read under various installation
conditions. The housing cover with built-in display can be fastened to the housing at
all four side positions.

4.3

Housing Reconfiguration

Rotate the housing of the display unit in order to be able to read the display from
above when the pressure transmitter is installed in an upright position.

• Loosen the 4 internal hexagonal screws.

• Lightly lift off the housing with the display unit.

• Carefully turn the housing by 180°.

• Re-tighten the screws.

When tightening the 4

hollow screws,

make sure that they are ade-

quately and securely seated in order to ensure that the transmitter is
properly sealed.

Connection Cable

Supporting String

Attention

This manual is related to the following products:

UT-10