Kramer Electronics VS-88DVI - Manual (Page 9)

6 VS-88DVI - Overview
Figure 2: VS-88DVI 8x8 DVI Matrix Switcher Rear Panel
# Feature Function
12 OUT DVI Connectors Connect to the DVI acceptors (from 1 to 8)
13 IN DVI Connectors Connect to the DVI sources (from 1 to 8)
14 RS-232 9-pin D-sub Port Connects to the PC or the RS-232 Remote Controller
15 Ethernet Connector Connects to the PC or other Ethernet Controller
16 RESET Button Press the reset button to reset to the Ethernet factory default definitions:
IP number
− 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
First disconnect the power cord and then connect it again while pressing the RESET button. The unit powers
up and loads its memory with the factory default definitions
17 REMOTE IR Opening Connects to an external IR receiver unit for controlling the machine via an IR remote controller instead
of using the front panel IR receiver
Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this
opening
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if
the internal IR connection cable has been installed)
18 Power Connector with Fuse AC connector enabling power supply to the unit
19 Power Switch Switch for turning the unit ON or OFF
6
VS
-88D
V
I –
O
v
er
vi
e
w