Kramer Electronics VS-88DVI - Manual (Page 14)

VS-88DVI - Operating the VS-88DVI 11
6 Operating the VS-88DVI
This section describes how to:
•
Route inputs to outputs (see Section 6.1 )
•
Disconnect outputs (see Section 6.2 )
•
Store and recall a setup (see Section 6.3 )
•
Acquire the EDID (see Section 6.4 )
•
Control the machine via RS-232 (see Section 6.5 )
•
Control the machine via the Ethernet port (see Section 6.6 )
6.1 Routing Inputs to Outputs
To route an input to an output:
•
Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
•
Press ALL followed by an IN button. The input is routed to all outputs
6.2 Disconnecting the Outputs
To disconnect one output:
•
Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
•
Press the ALL button and then press OFF. This disconnects all the outputs
6.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 16 setups and then recall
them, as Figure 4 illustrates:
IN 1 is used for setup # 1 and OUT 1 is used for setup # 9.