Kramer Electronics VS-88DVI - Manual (Page 12)

VS-88DVI - Connecting the VS-88DVI 9
5 Connecting the VS-88DVI
Always switch off the power to each device before connecting it to your
VS-88DVI. After connecting your VS-88DVI, connect its power and
then switch on the power to each device.
To connect the VS-88DVI, as the example in Figure 3 illustrates, do the following:
1. Connect up to eight DVI sources (for example, computer graphics sources)
to the IN DVI connectors.
You do not have to connect all the inputs and the outputs.
2. Connect the OUT DVI connectors to up to eight DVI acceptors (for example,
DVI displays).
3. If required, connect a PC and/or controller to the RS-232 port (see Section
6.5 ) and/or the Ethernet port (see Section 6.6 ).
4. Connect the power cord (not shown in Figure 3 ).
5. If required, acquire the EDID (see Section 6.4 ).
i