Kramer Electronics VS-66HN - Manual (Page 31)

28 VS-66HN - Protocol 3000
11 Protocol 3000
By default, the VS-66HN is set to Protocol 2000 (see Section 10 ) but is also
compatible with Kramer’s protocol 3000.
Note that the VS-66HN needs to be set to protocol 2000 in order to
use the IR remote control.
The VS-66HN can be operated using serial commands from a PC, remote
controller or touch screen using the Kramer Protocol 3000.
This section describes:

Kramer Protocol 3000 syntax (see Section 11.1 )

Kramer Protocol 3000 commands (see Section 11.2 )
11.1 Kramer Protocol 3000 Syntax
11.1.1 Host Message Format
Start Address (optional) Body Delimiter
# device_id@ Message CR
11.1.1.1 Simple Command
Command string with only one command without addressing:
Start Body Delimiter
# Command SP Parameter_1,Parameter_2,… CR
11.1.1.2 Command String
Formal syntax with commands concatenation and addressing:
Start Address Body Delimiter
# device_id@ Command_1 Parameter1_1,Parameter1_2,…|
Command_2 Parameter2_1,Parameter2_2,…|
Command_3 Parameter3_1,Parameter3_2,…|…
CR
11.1.2 Device Message Format
Start Address (optional) Body delimiter
~ Sender_id@ Message CR LF
i