Kramer Electronics VS-44FO - Manual (Page 3)

VS-44FO –
Contents i
Contents
1 Introduction 1
2 Getting Started 2
2.1 Achieving the Best Performance 2
2.2 Safety Instructions 2
2.3 Recycling Kramer Products 3
3 Overview 4
3.1 Defining the SFP 5
3.2 Defining the VS-44FO 4x4 3G HD-SDI Fiber Optic Matrix Switcher 5
4 Installing in a Rack 8
5 Connecting the VS-44FO 9
5.1 Installing the SFP Modules 11
5.2 Connecting the RS-232 Port 12
5.3 Connecting a PC or Controller to the RS-485 Port 14
5.4 Switching Genlocked Video Signals 15
5.5 Connecting the Ethernet Port 16
5.6 Configuring the Ethernet Port Initially 18
5.7 Controlling Using the Ethernet Port 20
5.8 Using the Ethernet Reset Button 20
6 Operating the VS-44FO 21
6.1 Operating the VS-44FO from the Front Panel 21
6.2 Using Serial Commands 24
6.3 Using the Infrared Remote Controller 24
6.4 Upgrading the Firmware 25
6.5 Changing the Device Parameters 25
7 Technical Specifications 26
8 Default Communication Parameters 27
9 Kramer Protocol 3000 28
9.1 Switching Protocols 28
9.2 Kramer Protocol 3000 Syntax 29
9.3 Kramer Protocol 3000 Commands 32
10 Hex Table (Protocol 2000) 35
11 Kramer Protocol 2000 36
Figures
Figure 1: VS-44FO 4x4 3G HD-SDI Fiber Optic Matrix Switcher Front Panel 6
Figure 2: VS-44FO 4x4 3G HD-SDI Fiber Optic Matrix Switcher Rear Panel 7
Figure 3: Connecting the VS-44FO 11
Figure 4: Installing the SFP Modules 12
Figure 5: DIP-Switch Settings 14
Figure 6: Local Area Connection Properties Window 17
Figure 7: Internet Protocol (TCP/IP) Properties Window 17
Figure 8: K-UPLOAD Main Screen 18
Figure 9: Connect Screen 19
Figure 10: Device Properties Screen 19