Kramer Electronics VP-773AMP - Manual (Page 78)

VP-773AMP - The VP-773AMP RS-232 Communication Protocol 73
73
Network settings commands
Network settings commands require admin authorization
Command Syntax Response
DHCP_MODE =
0 (factory default) – Don't use DHCP (Use IP set by factory or IP set command).
1 – Try to use DHCP, if unavailable use IP as above.
2 – Try to use DHCP, if unavailable use AUTO-IP as described here:
http://support.microsoft.com/kb/q307287/ .
Change
protocol
Ethernet port ETH-PORT PROTOCOL , PORT
ETHP ETH-PORT PROTOCOL ,PORT
RESULT
Read protocol
Ethernet port ETH-PORT? PROTOCOL
ETHP? ETH-PORT PROTOCOL , PORT
PROTOCOL = TCP / UDP
(transport layer protocol
)
PORT =
Ethernet port to enter protocol 3000 commands.
1-65535 = User defined port
0 - reset port to factory default (50000 for UDP, 5000 for TCP)
Load new
peripheral
firmware P Step 1: LDFW SIZE
Response 1: READY or LDFW SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDFW SIZE RESULT
Load new video
core firmware Step 1: LDFWS SIZE
Response 1: READY or LDFWS SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDFWS SIZE RESULT
Load new
audio/graphic
memory file Step 1: LDMFS SIZE
Response 1: READY or LDMFS SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDMFS SIZE RESULT