Kramer Electronics VP-773AMP - Manual (Page 27)

22 VP-773AMP - The OSD Menu
The display mode setup, shown in Figure 11 , is part of the entire system control
and the selected Single Window also shows the current aspect ratio (Best Fit):
Figure 11: Select the Display Mode
6.2.1 Window Customization
Window customization lets you change the size and position of a selected window.
Make sure that you have control over the window that requires customization (Main
Window Control or PiP Window Control). If not, select it via the OSD item in the
Miscellaneous menu, see Section
6.8
.
In the following examples, PiP Window Control is selected, but the same procedure
applies to Main Window Control.
Note that you can also customize the window size and position via the
“Y” commands (see
Section 12.2 ) or protocol 3000 (see Section 12.4 ).
6.2.1.1 Changing the Size of the Main and/or PiP Window
Use the H Width and V Height to change the size of the window using the + and
–
buttons on the front panel or remote control transmitter (as illustrated in Figure 12 ).
i