Kramer Electronics VP-773AMP - Manual (Page 18)

VP-773AMP - Connecting the VP-773AMP 13
13
6. Connect the HDMI 1 OUT connector to an HDMI acceptor (for example, a
plasma display).
You can also connect the HDMI OUT 2 output (not shown in Figure 4 )
7. Connect the HDBT RJ-45 connector to a receiver (for example, the Kramer
TP-580Rxr).
8. Connect the AUDIO LINE OUT Terminal Block connector to a balanced
audio acceptor and the S/PDIF OUT RCA connector to a digital audio
acceptor (not shown in Figure 4 ).
9. Connect the SPKR OUT block connector to a pair of loudspeakers, by
connecting the left loudspeaker to the “L+” and the “L-” terminal block
connectors, and the right loudspeaker to the “R+” and the “R-” terminal block
connectors. Do not Ground the loudspeakers.
10. If required, you can connect a PC and/or controller to the:
 RS-232 terminal block (see Section 8.3.2 )

Ethernet connector (see Section
8.3.3
)
11. Connect the power cord (not shown in Figure 4 ).