Kramer Electronics VM-24H - Manual (Page 17)

14 VM-24H - Operating the VM-24H
5. While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.
6.3.2 Acquiring the Default EDID
To reset to the default EDID (the factory-default programmed into the VM-24H
before it is shipped), do the following:
1. Connect the power supply.
2. Press the EDID SELECT button and set it to the Default EDID mode.
All the OUTPUT STATUS LEDs flash simultaneously.
3. Press the EDID READ button to copy the default EDID to the inputs.
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.
6.3.3 Acquiring the Auto-Mix EDID from the Connected Outputs
To acquire the Auto-mix EDID:
The EDID acquired is a weighted average of all the connected outputs. For example, if several
displays with different resolutions are connected to the outputs, the acquired EDID supports all
the resolutions, as well as other parameters included in the EDID.
1. Connect the power supply.
2. Connect the desired output display devices.
3. Enter the Auto-mix mode as defined in the preceding table.
All the OUTPUT STATUS LEDs light.
4. Press the READ button to copy the EDID of the selected OUTPUT to the
inputs.
While the EDID is being copied, the EDID SELECT and READ buttons
illuminate.
The new EDID is copied when both buttons no longer illuminate.