Festo Контроллер крайних положений SPC11 - Manual (Page 33)

2. Parameters of the SPC11 for the DNC-...
2-5 Festo P.BE-SPC11-DNC-EN en 0012NH
2.2 Setting the parameters
Warning
Incorrectly set parameters can cause damage to the fixed
stops and to the drive.
Always set the amplification and cushioning stages for the
maximum mass load used. If in doubt, set first the ampli-
fication and cushioning stages for the larger mass load.
The specified positioning times as well as optimum system
behaviour specified in section 2.3 can only be achieved, if the
installation instructions described in the previous section are
observed. The resulting positioning times depend on the
actual stroke length used and can vary depending on the
direction of stroke.
Further instructions on the amplification and cushioning
stages can be found in the System manual.
Set the parameters as follows:
1. Use the tables in section 2.3 to ascertain the parameters
which are valid for your application (amplification stage,
cushioning stage and system parameters).
2. Then set the parameters accordingly. Proceed here as
described in the chapter “Commissioning” in the System
manual (type P.BE-SPC11-SYS...).
The following diagram shows the table structure: