Festo Линейные модули HMP - Manual (Page 36)

HMP−...−B−...
Festo HMP−...−B−... 0408NH English
36
S Fasten the work load in one of the followĆ
ing ways:
ć Dovetail fastening
ć Sliding block fastening (only with
HMP−25/32−...; sliding blocks see
Accessories)
ć Direct fastening
Fitting pneumatic components
S Note that the compressed air connections are exhaust−restricted at the factory.
Controlling linear module type HMP−...−B:
S Use a 5/2−way valve (pressurized in basic
position).
If fitted in a vertical or sloping position:
S Check whether non−return valves with
control of type HGL−... (with high flow
rate) are necessary.
Otherwise the work load will slide down if
there is a drop in pressure.
S Check whether a compensation reservoir
type VZS−... is required.
This will reduce fluctuations in pressure in
the downstream−switched compressed air
string.
S Connect the pneumatic tubing as follows
(Fig. 15):
ć Port A (connection extending)
ć Port E (connection retracting)
Fig. 13
Fig. 14
E A
Fig. 15
(E)
(A)