Muxlab CATV Hub - Manual (Page 12)

© MuxLab Inc. CATV Distribution Hub Installation Guide
Page 12
5. At each RF receiver/tuner or cable modem, connect a CATV Balun II
(500302).
6. Connect a Cat5 (or better) cable between the CATV Distribution Hub and
each CATV Balun II. Please note that only one twisted pair is required.
The three (3) unused twisted pairs may be used for other low voltage
services, including low voltage power, data, voice, video, audio and IR.
7. Power on the CATV Distribution Hub and each receiver/tuner/cable
modem.
8. At each receiver/tuner, select each video channel to ensure that each
channel is received clearly. If the images on some channels are not clear,
please consult the Troubleshooting section of this installation guide.
9. If a cable modem is connected, test the Internet connection to ensure that
both upstream and downstream communications are functional. If not,
please consult the Troubleshooting section of this installation guide.
10. The following diagrams show a couple of typical configurations.