Muxlab Component Video Hub - Manual (Page 10)

© MuxLab Inc. Component Video Hub Installation Guide
Page 10
component video coaxial cable output of the video source according to the
color code of the RCA cable leads.
7. Connect a Component Video/Digital Audio Balun (500050, 500051) or
Component Video/Analog Audio Balun (500052, 500053) to each
component video display.
8. Complete the connection between the component video source and the
Component Video Hub using standard straight-thru Cat5 twisted pair cable
and connecting hardware, terminated on RJ45 plugs at both ends. Ensure
that there are no split pairs or taps.
9. Complete the connection between the hub and each component video
display using standard straight-thru Cat5 twisted pair cable and connecting
hardware, terminated on RJ45 plugs at both ends. Ensure that there are no
split pairs or taps.
10. If audio is to be connected (optional), connect an RCA lead between each
Component Video Balun and the audio equipment at both ends.
11. Connect the external 12VDC power supply to the hub and plug the power
supply into an AC power outlet. If power is present, then the green power
LED will be ON.
12. Power-on the component video equipment. Check the image quality and
refer to the troubleshooting table below if the image quality is
unsatisfactory.