Setting up your saw – SawStop CB73480 User Manual
Page 21
SawStop 10” Industrial Cabinet Saw 19
Setting Up
Your Saw
Note: some users may find it easier to adjust the brake position by opening the motor cover and removing the
dust shroud door to see the blade and brake cartridge more clearly. To remove the dust shroud door, loosen
the thumb screw and lift the door upward until the pivot pin in the door clears the pivot hole in the cast iron
trunnion brace (see Fig. 10).
Using the 8 mm hex L-wrench included with the saw, turn the spacing adjustment bolt clockwise to decrease
the spacing between the brake cartridge and the edge of the blade, and counter-clockwise to increase the
spacing. Adjust the brake position as needed to set the spacing between the teeth of the blade and the closest
point on the brake cartridge to between
1/16th and 1/8th inch (see Fig. 11).
A close-up of the area
inside the circle is shown
in Fig. 12, on page 20.
Setting Up Your Saw
Fig. 10
Fig. 11
dust shroud door
thumb screw
Cabinet Saw Manual 1st Reprint.i19 19
3/9/2010 8:32:44 AM