SawStop ICS73600 - Manual (Page 44)

42 SawStop 10” Industrial Cabinet Saw
You can change the brake cartridge either from the top of the saw through the table opening, or from the right
side of the saw through the opening behind the motor cover. To change the cartridge from the right side, first
open the motor cover. Next, remove the dust shroud door by loosening the thumb screw at the front of the door
and lifting the door upward until the pivot pin clears the mounting shaft. See Fig. 11 on page 19.
The brake cartridge is mounted on a large pivot pin
and a smaller positioning pin as shown in Fig. 42.
Both the pivot pin and positioning pin extend
outward from a cartridge mounting bracket that
sets the position of the cartridge. The cartridge
mounting bracket also holds a computer cable
that self-aligns to the computer connector in the
side of the cartridge. A cartridge key is used to lock
the brake cartridge in place against the cartridge
mounting bracket.
Removing a Brake Cartridge: to remove the
cartridge, first remove the cartridge key by turning
it 90° clockwise and then pulling it away from the
cartridge (see Fig. 43). Set the cartridge key aside
for use with the new cartridge.
It may take a small amount of force to turn the key
and pull it out. Make sure you turn the key a full
90°, as the key cannot be pulled out unless it has
been fully rotated.
Using Your Saw
Fig. 42
pivot pin
cartridge
key
positioning
pin
Fig. 43
Industrial Cabinet Saw Rev. 2 Ma42 42 3/9/2010 8:38:50 AM