SawStop ICS73600 - Manual (Page 27)

SawStop 10” Industrial Cabinet Saw 25
Setting Up
Your Saw
12. Disconnect Switch:
The saw is equipped with an electrical disconnect switch mounted
on the left side of the cabinet. When the disconnect switch is
switched to OFF (see Fig. 20), electrical power is physically
disconnected from the entire saw, including the SawStop safety
system. The disconnect switch should be switched to OFF
whenever performing any adjustments, maintenance or repairs
to the saw, including changing blades, installing or removing the
blade guard and riving knife, etc.
Setting Up Your Saw
In addition, the disconnect switch can be locked in the OFF position with a padlock or similar device as shown
in Fig. 21. The disconnect switch should be locked in the OFF position whenever there is a possibility of
someone accidentally applying power to the saw while adjustments, maintenance or repairs are being made.
When the saw has been completely installed and is ready for use, turn the disconnect switch to ON as shown
in Fig. 22.
Fig. 22 Fig. 21
Fig. 20
Industrial Cabinet Saw Rev. 2 Ma25 25 3/9/2010 8:38:39 AM