Australian Monitor DMA1 - Manual (Page 14)

C O N F I G U R AT I O N F I L E
PA G E 1 4 A M I S - D M A 1 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
4.10 Infrared movement sensor management parameters
IMPORTANT: the following parameters are enabled exclusively for the IN1 input.
Example: PYDT=1
PYDL=10
TAPL=0
RSPL=3
MNEMONIC DESCRIPTION
PYDT Activation of IR sensor on IN1 logic input (0=OFF/1=ON )
PYDL Delay time between the completion of playing an MP3 fi le and the next IR sensor activation
(value between 0 and 240 in decimal)
TAPL Setting of the AUTOPLAY time for playing of a message when the IR sensor is not activated
(value between 0 and 240 in decimal)
RSPL Delay time between IR sensor movement detection and commencement of MP3 playback
(value between 0 and 20 in decimal)
PYDT (ACTIVATION INFRARED MOVEMENT SENSOR)
PYDT 1 = IR sensor activated
0 = IR sensor deactivated
PYDL (DELAY TIME BETWEEN END OF MP3 PLAYBACK AND IR SENSOR RE-ACTIVATION)
VALUE 0 1 2 3 4 5 10 20 30 60 120 180 240
TIME IR 1 2 3 4 5 10 20 30 1 2 3 4
second seconds seconds seconds seconds seconds seconds seconds minute minutes minutes minutes
TAPL (SETTING AUTOPLAY TIME FOR PLAYING FILES WHEN THE IR SENSOR IS NOT ACTIVATED)
VALUE 0 1 2 3 4 5 6 12 18 30 60 180 240
TIME NOT 10 20 30 40 50 1 2 3 5 10 30 40
managed seconds seconds seconds seconds seconds second seconds seconds minutes minutes minutes minutes
RSPL (DELAY TIME BETWEEN IR MOVEMENT DETECTION AND START OF MP3 PLAYBACK)
VALUE 1 2...4 5 6...9 10 11...14 15 16...19 20 21...24 25 26...49 50
TIME 1/10 1/2 1 1,5 2 2,5 5
second second second seconds seconds seconds seconds