Australian Monitor DMA1 - Manual (Page 13)

C O N F I G U R AT I O N F I L E
PA G E 1 3 A M I S - D M A 1 I N S TA L L AT I O N & O P E R AT I O N M A N U A L
4.9 Input management parameters
The playing of MP3 fi les takes place by activating the logic inputs. The
activation modes are set through the IMOD, TPCM MICP and MIRS param-
eters inserted in the confi guration fi le.
Example: IMOD=0
TPCM=10
MICP=1
MIRS=0
MNEMONIC DESCRIPTION OF TIMING PARAMETER
IMOD Setting the mode of the logic inputs as either active high or active low
TPCM Setting the persistence time of the input command (time to wait before the DMA1
interprets the input command) expressed in decimals of milliseconds (value between
0 and 255 in decimal).
MICP Setting Mode Input Continuous Play
MIRS Setting Mode Input ReStart
IMOD (INPUT MANAGEMENT MODE)
IMOD 0 = active-low input mode; the logic input is active when connected to the ground/GND of the device
1 = active-high input mode; the logic input is active when connected to a positive voltage
between 5 and 12VDC
TPCM (TIME PERSISTENCE INPUT COMMAND MODE)
TPCM 0 = no delay 100= 1 second
1 = 10mSeconds 200= 2 seconds
2 = 20mSeconds 250= 2.5 seconds
MICP (MODE INPUT CONTINUOUS PLAY)
MICP 0 = having terminated the playing of the MP3 fi le, the DMA1 goes into standby
1 = the requested MP3 fi le is continuously played until a new input code is entered
MIRS (MODE INPUT RESTART)
MIRS 0=repeated activation or deactivating of the same input code does not infl uence the
playing of the relevant MP3 fi le. Only the activation of a different code can stop the playing
of the current MP3 fi le and activate the playing of a new MP3 fi le
1=The relevant MP3 fi le commences playing from the beginning, even if the same MP3 is already in play